Forum General Discussions Re: NDT PROCEDUCE Posted by: Mike Fortman , E-mail: Address, on August 18, 2008 at 23:13 : In Reply to: NDT PROCEDUCE posted by : HUNG , E-mail: Address, on August 11, 2008 at 04:49 : ----------- Start Original Message ----------- : in according to AMM;CMM. the part(ex: tie bolt) required FPI but there is not NDT instruction. during perfomed this task i usually refered ASTM Proceduce or SOPM instruction. in your idear is it correct or incorrect? Need i require NDT level iii writing NDT instruction for me or not? : thank's. ------------ End Original Message ------------ Hello Mr. Hung, I beleive you are referring to aircraft wheel tie bolt inspection according to the aircraft maintenance manual (AMM) or component maintenance manual (CMM). It is unusual for the tie bolts to require FPI. Most require magnetic particle (MPI). In my experience, if no specification is listed, the ASTM (in this case, E1417) is usually an acceptable procedure. The best thing to do is contact the wheel manufacturer and ask what spec to use. Please contact me via e-mail if you'd like to discuss further. Mike Follow Ups: Re: NDT PROCEDUCE nelson 11:42 Aug-19-2008 (1) Re: NDT PROCEDUCE Michel Couture 17:06 Aug-19-2008 (0) Post a Followup: Name: E-Mail: Subject: Comments: ----------- Start Original Message ----------- : : in according to AMM;CMM. the part(ex: tie bolt) required FPI but there is not NDT instruction. during perfomed this task i usually refered ASTM Proceduce or SOPM instruction. in your idear is it correct or incorrect? Need i require NDT level iii writing NDT instruction for me or not? : : thank's. : Hello Mr. Hung, : I beleive you are referring to aircraft wheel tie bolt inspection according to the aircraft maintenance manual (AMM) or component maintenance manual (CMM). : It is unusual for the tie bolts to require FPI. Most require magnetic particle (MPI). In my experience, if no specification is listed, the ASTM (in this case, E1417) is usually an acceptable procedure. : The best thing to do is contact the wheel manufacturer and ask what spec to use. : Please contact me via e-mail if you'd like to discuss further. : Mike ------------ End Original Message ------------ Optional Link URL: Example: "http://www....html". Alternative write "http://www.ndt.net/wshop/attach/filename.htm" if you transfered a filename.htm via FTP Page Title: is important! Optional Image URL: http://www....gif Attention! Please click the button only once. This may take a moment to process Forum General Discussions Help