Forum General Discussions NDT PROCEDUCE Posted by: HUNG , E-mail: Address, on August 11, 2008 at 04:49 : in according to AMM;CMM. the part(ex: tie bolt) required FPI but there is not NDT instruction. during perfomed this task i usually refered ASTM Proceduce or SOPM instruction. in your idear is it correct or incorrect? Need i require NDT level iii writing NDT instruction for me or not? thank's. Follow Ups: Re: NDT PROCEDUCE Mike Fortman 23:13 Aug-18-2008 (2) Re: NDT PROCEDUCE nelson 11:42 Aug-19-2008 (1) Re: NDT PROCEDUCE Michel Couture 17:06 Aug-19-2008 (0) Post a Followup: Name: E-Mail: Subject: Comments: ----------- Start Original Message ----------- : in according to AMM;CMM. the part(ex: tie bolt) required FPI but there is not NDT instruction. during perfomed this task i usually refered ASTM Proceduce or SOPM instruction. in your idear is it correct or incorrect? Need i require NDT level iii writing NDT instruction for me or not? : thank's. ------------ End Original Message ------------ Optional Link URL: Example: "http://www....html". Alternative write "http://www.ndt.net/wshop/attach/filename.htm" if you transfered a filename.htm via FTP Page Title: is important! Optional Image URL: http://www....gif Attention! Please click the button only once. This may take a moment to process Forum General Discussions Help